0%

CORAL

ENGINEERED FOR THE FACILITIES THAT CAN'T AFFORD TO STOP

Foundry

Foundry

Introduction to fume and particle control for foundry applications

High temperature extraction and filtration for casting, molding and finishing work.

Foundry applications release a large number of toxic fumes and heavy metal particles, and the dust that comes with them carries silica from the sand. Both are hazards, for the health of your crew and for the safety of the building.

Foundry dust collection has to survive its own operating conditions before it filters anything. Air arrives hot, the material is abrasive, and the load changes completely between the pour, the shakeout and the finishing bay. Equipment specified from a single average figure fails at whichever end of that range it was not sized for.

Coral USA builds stationary units for exactly this duty, in modular form so one line can be specified separately from the next. Cartridge units carry high workload and high airflow with a large filter surface and fewer cleaning cycles. Sleeve units take the abrasive fraction without clogging the media.

Products

For Foundry

Problems with foundry fumes and dust

Foundry workers are exposed to fine dust carrying silica, ferrous particulate, metal dust and fume. Uncontrolled, that exposure leads to silicosis and to lung cancer, which is why a proper extraction system is a legal requirement in many jurisdictions rather than a discretionary purchase.

Fine metal dust is also highly combustible. Accumulation in the workplace turns into property damage, explosion and injury, and the accumulation is invisible right up until it is not.

Foundry workers pouring molten metal into moulds

Coral USA foundry dust and fume extraction solutions

A comprehensive range of modular, customizable extraction and collection units covers the whole plant. Stationary cartridge units suit applications demanding high workload, high airflow and heavy pollutant loads, with a large filter surface area designed for maximum efficiency across fewer cleaning cycles.

Where the dust is more abrasive and aggressive, stationary sleeve units extract a higher load without cartridge clogging. Because the stationary systems are modular, they adapt to the layout that exists rather than requiring the plant to be arranged around them.

Coral Aircompact dust collector in a foundry building

FAQ

Foundry Dust Collection Questions

Because air arrives hot from the pour and the shakeout, and equipment sized on ambient conditions is being asked to do something it was never specified for. Media selection, ducting and fan choice all change once inlet temperature is part of the duty.

Silica from the sand, ferrous particulate, metal dust and fume. Silica is the exposure that leads to silicosis and lung cancer, which is why proper extraction is a legal requirement in many jurisdictions rather than a discretionary purchase.

Cartridges suit high workload and high airflow with a large filter surface and fewer cleaning cycles. Sleeves take the abrasive fraction without clogging, so the answer often differs between the pour, the shakeout and the finishing bay inside the same plant.

Fine metal dust is highly combustible, and accumulation in the workplace leads to property damage, explosion and injury. The accumulation is invisible right up until it is not, which is why collection is sized to prevent it forming rather than to clean it up afterwards.

Only if it is modular. The load changes completely between casting, molding and finishing, and Coral USA stationary units are built in modular form so each line is specified separately and extended later without replacing the collector.

Search products